Press the Black button or the Color button to release the error, then take appropriate action. If adjusting the print head position has failed, the Alarm lamp flashes. Do not open the document cover or move the print head alignment sheet on the platen glass until adjusting the print head position is complete.Remove the print head alignment sheet on the platen glass.
The print head position adjustment will be complete when the ON lamp lights after flashing. The machine starts scanning the print head alignment sheet, and the print head position will be adjusted automatically. Ĭlose the document cover gently, then press the Black button or the Color button. Load the print head alignment sheet WITH THE PRINTED SIDE FACING DOWN and align the mark on the bottom right corner of the sheet with the alignment mark. Load the print head alignment sheet on the platen glass. Scan the print head alignment sheet to adjust the print head position.
Do not touch any printed part on the print head alignment sheet.The print head alignment sheet will be printed. Hold down the Stop button until the Alarm lamp flashes four times, then release it immediately. Pull out the paper output tray and the output tray extension.
Load a sheet of A4 or Letter-sized plain paper in the rear tray. * Be sure to use paper that is white and clean on sides. You need to prepare: a sheet of A4 or Letter-sized plain paper (including recycled paper)* Replace the FINE Cartridge whose ink is low. If the remaining ink level is low, the print head alignment sheet will not be printed correctly. When you have successfully disabled the status monitor, you will no longer get reports of empty cartridges when they still contain ink.If printed ruled lines are misaligned or print results are otherwise unsatisfactory, adjust the print head position.
If you have the status monitor open on your screen, you should see yellow exclaimation marks (status monitor thinks there is a problem) change to red crosses (status monitor off), like this: The printer will usually beep to acknowledge, but this varies from model to model.ĭepending on your printer model, you may need to turn it off and on again for this to be registered, and you may also need to repeat the process for each cartridge. The symbol is always the same though, it's a red circle enclosing an inverted triangle:Īll you need to do is to hold this button down for 5-10 seconds. First, locate the button that will do this - it's on the front panel of the printer and may be marked "STOP", "RESUME", "CLEAR", "RESET" or any combination of these. The easiest fix is to turn off the status monitor.
#Inklevel on canon mg2922 manual
Older models have a numeric error report, you may see the error codes U162, U163, E005, or 1401 - there are others, this advice refers to any error that your manual informs you is related to ink levels. You may see a graphic representation on your screen that looks something like this: This can sometimes prevent printing altogether. The Canon status monitor is unusually difficult to work with, and will often report cartridges as empty or low on ink when they have just been replaced. Inkjet printers do not contain any mechanism to measure the amount of ink left in a cartridge - any values that the printer or status monitor give you are estimates based the number of pages printed since the cartridge was last changed.
0 kommentar(er)
